Air Filters

Click on the image to enlarge

Tools

3/4 Drive:
Ratchet
8mm socket
6" extension bar

3/8 Drive:
Ratchet
10mm socket
10" or 12" extension bar

Pozidrive or Phillips Screw Driver

Guide:

Start by uncliping the top half of the air intake box, and remove the panel filter. 

Use the 3/8 Drive equipment to remove the x4 bolts holding the lower part of the airbox to the chassis.

Using the 3/4 Drive equipment, unfasten the clip that attaches the pipe from the box to the AFM, and remove the rubber pipe by pulling it away.

Using the screwdriver, undo the air intake funnel thats attached to the slam panel on the front of the car. This can be removed while still attached to the lower half of the air box.

Line up the Apexi bolt holes with the 4 that correspond (line up) with the ones on the AFM.

As you look down on the AFM, the lower right bolt used should be the longest one, as this needs the support bracket fixing to it, and bolts to the chassis in one of the holes the original air box used.

Tighten them gently in diagonal sequence, you dont have to "go nuts" when tightening.

Remember to do an ECU reset.