Apexi Power FC Setup
 

 The most important thing here is to familiarise yourself with the hand commander. The buttons are relatively simple, up down, left and right, previous & next.

So turn the key to the "ACC" position so the instrument panel lights up, and so will the screen on the Hand commander and the Apexi logo should be there, and it will then load up the options menu which consists of:

Monitor
1 Channel - single channel monitoring of a component
2 Channel - dual channel monitoring of a component
4 Channel - you get the picture
8 Channel
Map Tracer- Shows a graph of engine rev actiivity

Systems available for monitoring:

Inj Duty (injector)                      Boost
Ign Tmg (ingnition timing)      Knock (detonation)
Air Flow                                      Wtr temp (water)
Engine Rev                                Air temp
Speed                                         Bat volt


You should select Knock, Bat Volt, Water Temp and air flow at the very least.

To select the amount of channels you want use the down button and then "next" button on the required channel.
To select them use up and down button to scroll through, and right button to select, then a number will appear next to it.

For example:
       Inj duty  
     Ign Tmg  
    1  Knock      
    2 Speed       

So with "knock and speed" being selected, you then press "next" where it will take you into the monitoring screen.

Before I forget, Speed is measured in Km/h and not M/ph.

This concludes "Monitor" setup.

Setting
IGN MAP         ACCEL
INJ MAP         IGN/INJ
AIRFLOW       CRANKING
INJECTOR      WTR TMP
BOOST           REV / IDLE

LEAVE THESE ALONE, DO NOT ALTER UNLESS YOU KNOW WHAT YOUR DOING.

Etc
Prog Version + NEXT =              RB25DET POWER FC
                                                        Version 5.11 FC Commander 3
                                                        Version 5.01A
Sensor / Sw check + NEXT =
AF- 1:      1.05v                     IGN          O               ECC    O    
THRO:     0.45v                    STR         O               WRN   O   
BOST:     0.00v                    A/C          O                EXT    O   
WTRT:     1.24v                    PWS       O                 F/P      O  
02 -1:       0.02v                   NTR          O               FP1      O   
EXTM:     5.00v                   ***                               VTC      O 
****:         0.00v                   ***                               02H      O 
****:         00.v                     ***                               ACR      O 


Function Select
1. Boost Cntl Kit          + ; ' )     
2. Airflow Warn           P ' )   
3. Inj                               P ' )
4. Knock                       P ' )
5. 02 F/B Control        P ' )